Ozone for Above-Ground Pools: How to Set It Up Properly

Short answer: yes, you can run an ozone generator on an Intex or other above-ground pool. The trick is to feed the ozone in through your filter pump with a venturi, not to bubble it in with an aquarium air pump. Set up that way, ozone takes over much of the cleaning work and you can run the pool on less chlorine.

Key takeaways

  • Fit a venturi to the return hose of your filter pump - the water flow draws the ozone in and mixes it.
  • Put it after the filter, as the last fitting before the water goes back to the pool.
  • An air pump and stone is fine for a cold plunge or small tub, but not for a full-sized pool.
  • Mount the generator dry and above the water line, with a check valve in the tubing.
  • Run it whenever the filter pump runs. A stream of fine bubbles at the return tells you it is working.
  • Ozone leaves nothing behind in the water, so an outdoor pool still needs a low level of chlorine - just less of it.

Why a venturi and not an air pump?

Ozone only cleans water it has actually dissolved into. Bubbling it through a stone is the simplest method, but also the least efficient - in shallow water much of the ozone reaches the surface and escapes before it dissolves. In a cold plunge or small tub that does not matter, because there is so little water that enough ozone still gets in. In a pool of around 10,000 litres, what does dissolve is spread far too thin to do much.

A venturi solves this. It is a small fitting with a narrowed throat that goes in-line in the hose carrying water back to the pool. As water speeds up through the throat it creates suction, which pulls ozone in from the generator and mixes it thoroughly on the way back to the pool. Every litre that passes through the filter gets a dose - the same principle as the ozone injector in a spa pool.

Pool Water out Filter pump Venturi Check valve Ozone Spa-zonator Dry, and above the water line Back to pool Inside the venturi Ozone drawn in Water from filter Ozonated water to pool Faster water through the throat creates suction
How the Spa-zonator connects to an above-ground pool: a venturi on the filter return hose draws the ozone in.
Venturi on the filter pump Air pump and stone
Best for Pools and spa pools Cold plunges, ice baths, small tubs
Mixing Ozone is drawn into the moving water and mixed in the hose Bubbles rise and much of the ozone escapes
Water it can treat All the water that passes through the filter A few hundred litres
Extra parts Venturi sized to your hose Air pump, stone, tubing

How to set it up

1Fit the venturi

Install it in the return hose, after the filter, as the last fitting before the pool. Match it to your hose diameter.

2Mount the generator

Somewhere dry, sheltered and above the water line. Put a couple of loops in the tubing and fit the check valve so water can never run back into the unit.

3Run it with the pump

Plug the generator into the same timer as the filter pump so it only makes ozone when water is flowing.

Getting good suction

A venturi does not need a powerful pump. It works on the drop in pressure as water passes through its throat, and the Spa-zonator needs only a gentle draw - about 3 litres of air a minute. In our experience, pump size has not been a problem for customers. How the venturi is fitted matters more:

  • Fit it the right way round for the direction the water flows.
  • Make it the last fitting before the pool, and keep the hose after it short and free of kinks. Anything that restricts the water after the venturi reduces the suction.
  • Keep the filter and skimmer clean. A clogged filter slows the water, and the suction drops with it.
  • Test it before you connect the tubing. With the pump running, put your thumb over the venturi's air inlet - you should feel it pull.

Once the tubing is connected, look for a stream of very fine bubbles where the water returns to the pool. That is the ozone going in.

How much chlorine will I still need?

This is the honest part. Ozone does its work as the water passes the injection point and then turns back into oxygen. That is why ozonated water feels and smells so clean - but it also means nothing stays in the pool to keep working between filter cycles. An outdoor pool sitting in summer sun, with swimmers, sunscreen and leaves going in, needs something that stays in the water to hold off algae.

So think of it as a partnership. Ozone does the heavy oxidising work every time the pump runs, and a small amount of chlorine looks after the pool in between. With ozone carrying that load you can typically hold a lower chlorine level, with less of the combined chlorine that causes the familiar pool smell and sting. Test strips will show you how low you can go for your pool, your weather and how much it is used.

If algae does appear, switch the ozone off, give the pool a dose of chlorine, let it clear over a few days, then switch the ozone back on.

Why bother with ozone at all?

Because it is a far stronger and faster oxidiser than chlorine. In a laboratory study using purified Cryptosporidium parvum oocysts - the parasite best known for surviving normal pool chlorination - 1 ppm of ozone for 5 minutes inactivated more than 90%, while 80 ppm of chlorine needed around 90 minutes for the same result (Korich et al. 1990, Applied and Environmental Microbiology; laboratory study, viability measured by excystation and mouse infectivity). Read the study.

That is a laboratory comparison under controlled conditions, not a measurement of any particular pool system. It shows what ozone is capable of where it meets the water.

For a plain-language comparison of the two, see Ozone or Chlorine - you be the judge.

Practical tips

  • Check the check valve monthly and replace it yearly. A failed valve letting water into the generator is the most common cause of trouble.
  • Disconnect the tubing over winter if you shut the pool down.
  • Vinyl covers: ozone can wear vinyl over time, so have a look at the underside of your cover now and then.
  • Power: use an RCD-protected outdoor socket, and keep the unit out of splash range.

Common questions

Can I use ozone in an Intex or other above-ground pool?

Yes. Fit a venturi to the return hose so the water flow draws the ozone in, mount the generator dry and above the water line, and run it whenever the pump runs.

Do I need a bigger pump?

Not in our experience. A venturi works on the drop in pressure as water passes through it, and the Spa-zonator needs only a gentle draw - about 3 litres of air a minute. If the suction seems weak, check that the venturi is the right way round, that the filter is clean, and that nothing after the venturi is restricting the flow.

How do I know it is working?

With the pump running you should see a stream of very fine bubbles where the water returns to the pool, and no water in the ozone tubing. You may also notice a faint, fresh ozone smell near the water.

Will an aquarium air pump work in a pool?

Not well. An air pump and stone suits a cold plunge or small tub, where there is very little water to treat. In a full-sized pool much of the ozone escapes at the surface and what dissolves is spread too thin. A venturi on the filter pump is the right method.

I have read that ozone has to be dissolved and off-gassed before it reaches the pool. Is that a concern?

That advice is written for large commercial and indoor pool systems, which inject far more ozone in an enclosed space and use contact tanks and off-gas units. A small generator on an outdoor backyard pool is a different situation - it is in the open air, and any ozone that does not dissolve simply disperses.

Can I stop using chlorine completely?

For an outdoor pool, no. Ozone leaves no residual in the water, so a low level of chlorine is still needed between filter cycles to hold off algae. You can typically run a lower level than you would without ozone.

How long should I run it?

Whenever the filter pump is running. The simplest way is to plug both into the same timer.

Which generator do I need?

The Spa-zonator is a corona discharge unit producing up to 300 mg of ozone per hour. It connects by suction to a venturi, and comes with 2.5 m of ozone-resistant tubing and a check valve. The venturi itself is not included, so choose one to match your hose.

Ready to cut back on pool chemicals?

The Spa-zonator suits spa pools, cold plunges and above-ground pools fitted with a venturi on the return hose.

See the Spa-zonator

Many of our customers use ozone therapy at home as a complementary part of their wellness routine, alongside the care of their health practitioner.

×